Eldes EKB3 Manual de Instalação descarregar pdf (Página 147)

147

147EN

MANUAL ELDES ESIM264 V3.1

32.9.5.2. Battery Replacement

1. Turn EWF1 counter-clockwise to detach it from the mounting

plate.

2. Gently pull down the wireless smoke detector.

3. Remove the old battery from the battery pocket.

4. Postition the new 9V battery according to the appropriate

battery slot positive/negative terminals indicated on the

enclosure of EWF1. Ensure the plastic battery holder is fully

depressed when the battery has been tted.

5. Using the TEST button, test the wireless smoke detector to

verify if it is operational. See 32.9.5.1. Testing EWF1.

6. Re-attach the wireless smoke detector to the mounting plate

by turning the wireless smoke detector clockwise until it snaps

into place.

9V battery

ATTENTION: Only 9V 6F22 primary alkaline type battery can be used. Install only new, high quality and unexpired batteries.

ATTENTION: The battery must be removed if the device is not in use.

ATTENTION: In order to avoid re or explosion hazards, the system must be used only with approved battery. Special care must be taken

when connecting positive and negative battery terminals. Dispose old batteries only into special collection sites. Do not charge, disassemble,

heat or incinerate old batteries.

NOTE: The battery status can be monitored in real-time using ELDES Conguration Tool software.

NOTE: The system sends an SMS message to the preset user phone number as soon as the battery level runs below 5%.

32.9.6. Restoring Default Parameters

1. Remove the battery from EWF1.

2. Press and hold the RESET button.

3. Insert the battery back to EWF1.

4. Hold the RESET button until you hear a short beep.

5. Release the RESET button.

On some EWF1 models the RESET button is not available. On such EWF1 devices the reset process is as follows:

1. Remove the battery from EWF1.

2. Wait for 1 minute or more.

3. Press and hold the TEST button.

4. Insert the battery back to EWF1.

5. Hold the TEST button for 10 seconds or more.

6. Release the TEST button.

ATTENTION: EWF1 built-in speaker will sound while pressing and holding the TEST button. Please, ignore the sound.

32.9.7. Cleaning

Clean the wireless smoke detector at least once a month to remove dust, dirt, or debris. Using the soft brush or wand attachment of a

vacuum cleaner, vacuum all sides and cover of wireless smoke detector. Be sure all the vents are free of debris.

If necessary, use a damp cloth to clean wireless smoke detector cover.

NOTE: Do not attempt to remove the cover to clean inside the wireless smoke detector. This will void your warranty.

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 167 168

Comentários a estes Manuais

Sem comentários

Eldes EKB3 Manual de Instalação Página 147

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Eldes EKB3